Demonfx SIM-AMP Simplifier Bass Station Preamp Simulator …, Bukit Batok

Versatile Preamp Stage
The preamp stage is based on the Ampeg SVT ®. This amp stands out for it’s personality, versatility and articulation. Including its flexible EQ with +- 15dB per band, and the switchable midrange from 400-900-1200Hz.

Across most of the gain settings, the amp is tight and clear. But with higher gains, it will grunt and growl like a real Ampeg SVT does.
A PARALLEL UNIVERSE
The SIMPLIFIER BASS STATION separates the signal at the input for a parallel line, bypassing the preamp, and including a switchable low pass filter (100Hz, Off, 500Hz). The effect of blending this clean signal with the preamp tone let’s you overdrive the preamp while retaining a huge low end response and natural dynamics.
 
CABINET SIMULATION
The Cabinet simulation was carefully designed to get the most distinctive cabinet tones. A Closed Back 8x10, with its tight and punchy lows. A vented 1x15 for warm creamy mids and thick lows, and a vented 4x10 for more open, wider range response.
The Speaker color switch, Warm, Bright and Modern, simulates the different materials and geometry of bass speakers, which affects the dynamics and midrange response.
And with the Resonance and Mic position controls, you can adjust the exact amount of high end brightness and the cabinet low end resonance you want.
 
DUAL EFFECT LOOP
This page is used for listing the features offered by your company/service. You can add any feature you want or edit the ones that are already listed. You can edit all of this text and replace it with what you want to write.
Edit your Features from the Pages tab by clicking the edit button.
 
Powering Up:
Before powering up the unit, turn down the receiving device (PA, interface, headphones, etc) in order to avoid power up “pop”.
The best way to power up the Simplifier, is to use a 9V REGULATED DC adapter, make sure you are using a clean voltage source and you are not daisy chaining the power supply with high current digital units.
 Recommended Power supply:
● The Power supply specs should be:
● 9V to 12V DC voltage
● Regulated (designed for low noise, musical instruments use)
● 80 mA minimum current rating. You can use higher current rating supplies.
● Center negative.
* Do NOT use center positive supplies, it may damage the unit and it will not be covered by warranty. Please make sure the polarity is correct before powering up.

Connections
● Input Jack: Connect the bass here.
● Parallel FX Send: The parallel fx send output comes from the input, before the preamp. Put the effects you want to use with the “clean” signal chain here.
● Parallel FX Return: Return from the “clean” signal chain effects.
● Preamp FX Send: The preamp FX send comes after the preamp. Put the effects for the preamp side chain here.
● Preamp FX Return: Return from the “preamp” signal chain effects.
● TRS Out: Carries the main output (preamp + parallel blend) or the input signal (bypass), if selected.
● DI OUT: Carries the Main output (preamp + parallel blend) in a balanced si