Waterproof HID Access Control Card Reader Wiegand 26~37 …, Pasir Ris

Product parameters
Product name: HID Access Control Reader
Material: ABS & Resin adhesive (effectively waterproof)
Frequency: 125Khz
Card reading type: HID Access Control Card
Read Range: 3~15CM
Operating Voltage: DC 9~16V
Interface method: WG26~37
Operating Temperature: -25℃ ~ 85℃
Card reading interval: <0.5S
Verification method: Swipe Verification
Communication distance: Wiegand interface ≤ 100 meters, RS232/TTL, interface ≤ 10 meters, RS485 interface ≤ 1200, meters (recommended within 800 meters)
 
Installation Notes
1. Paste the sticker in the card reader box on the position where the card reader is to be installed, open two positioning holes and a middle outlet hole according to the marked position, and plug the positioning holes with rubber plugs. (Note: if it is installed on the wall If installed, the concealed installation needs to be embedded in the 86 installation box)
2. Use a Phillips screwdriver to unscrew the screws that fix the panel and the bottom plate, remove the bottom plate, and use the screws to fix the bottom plate to the wall on the side of the control entrance.
3. Pass the wire of the card reader through the outlet hole, connect the wires according to the instructions, and fix the screws of the card reader panel and the bottom plate.