【dinghingxi2】X14 ELRS AIO 5in1 Flight Controller Built-in …, Sembawang

FC:1.MCU: STM32G473CEU6
2.Gyro: ICM42688P
3. memory: 16MB
4.Sensor: Voltage & Current
5.BEC: 5V, Max. 2A

FC:
UART: UART 1, UART 2, UART 3 (For RX), UART 4(For VTX)
BetaFlight OSD: AT7456ELAH
ESC: 12A continuous
OPENVTX: 5.8GHz 48 channels, Max. 400mW
FC firmware target: CRAZYBEEG473
USB port: SH1.0-4Pin
Battery connector: XT30 or A30
Mounting hole size: 25.5mm x 25.5mm
ESC:
Power input: 1-2S Lipo input
Current: 12A continuous, 15A peak
ESC firmware: V0.19 48KHz Bluejay
Firmware target: Z_H_30_48KHz
Digital signal protocol: DShot300, DShot600
VTX:
OPENVTX Firmware
Support firmware upgrade by openvtx configurator
Output power: PIT/10/25/100/400
Frequency: 5.8GHz 48 channels, with Raceband: 5658-5917MHz
Channel SEL: SmartAudio2.1
Modulation type: FM
Operating temperature: -10℃-+80℃
Antenna port: /U.FL
RECEIVER:
Serial ExpressLRS 2.4GHz
Antenna: Enameled copper wire 31mm length
Firmware target: Happy Model EP1/EP2 2.4GHz RX
Telemetry output Power: Less than 12dBm
Compatible with ExpressLRS V3.x.x TX Module
ExpressLRS firmware version 3.0.1
Support flash firmware by WIFI
Bind method is the same like all ExpressLRS 2.4GHz receivers
Color: Black
Material: PCB

Package Contents:
1 x Flight Controller Kit

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.