40 round pot mold (ABS plastic mold with inner cavity), Sembawang

Welcome
- - We specialize in manufacturing and importing bonsai molds, fence molds, railing molds, edema... - Durable ABS plastic material, sharp pattern, no warping
Full inside, positioning, so it's easy to do
♥️ Dimensions: width 40cm * height 25cm * bottom 24cm
♥️ Material: Super durable virgin ABS plastic
---------------------------------------------------------------------
9 basic steps using ABS pot mold with inner heart for beginners:

-Preparation: 1 set of molds, brushes, buckets, flying, sand, crushed stones, cement, waste oil
- Install the mold firmly, keep it flat, catch screws
- Apply oil evenly all over face, inside. Beat the lake evenly by hand or by machine in the ratio of 1 cement: 1.5 sand: 1.5 stone and water
- Pour mortar into the mold (note the lake must be liquid enough to run evenly throughout the mold when pouring). Pour until it is just as full as the mouth of the pot. Use a rubber hammer to gently knock around (if using a vibrator, no need to type). Do not type hard will break the mold. When pouring, use a heavy object to avoid heart attack and breakage in the mold.
- - -After pouring 2-3 hours, proceed to withdraw inside. Do not leave it for too long, it will not be drawn inside (if you forget, let the pot dry completely for about 2-3 days.)
-Use to fly into the mouth after withdrawing the inside to make the mouth sharp and square
- Mold after pouring 24 hours to 48 hours (depending on the type of mold and weather) can remove the outer mold.
8. Polish
- - Paint pots. Let it dry for the first time and then sweep for the second time, wait for it to dry, then draw a pattern, wait for it to dry, then cover it.

Above is the basic potting technique. VERY HAPPY TO SERVE YOU