Radiolink R9DS 10CH SBUS PWM Receiver Long Range AT9 AT10 …, Singapore

Radiolink R9DS 10CH SBUS PWM Receiver Long Range AT9 AT10 AT9S AT10II Drone FPV RC Airplane Car

1️⃣ Long-Range 2.4GHz Control (Up to 2.1 Miles!)
✈ Ideal for FPV/Airplanes/RC Cars – With an outstanding 1500m (air) / 900m (ground) range and DSSS/FHSS anti-interference tech, enjoy stable, long-distance control even in noisy environments.

2️⃣ Dual SBUS & PWM Output (10 Channels Total)
???? Flexible Signal Options – Supports PWM (9CH) and SBUS (10CH) simultaneously. Quickly switch modes via LED indicator (red = PWM, blue/purple = SBUS).

3️⃣ Ultra-Fast Response & Low Latency
⚡ 4096 Resolution, 0.5μs Stability – Perfect for racing drones and high-speed RC models. Features one-second binding and reverse polarity protection for hassle-free setup.

4️⃣ Exclusive Radiolink Compatibility
???? Works Only with Radiolink TX: AT9/AT9S/AT10/AT10II (ensure SYSTEM channel is set to 10CH for AT10II). Note: Not compatible with other brands.

5️⃣ Compact & Durable Design
????️ Tiny but Tough – Just 11g and 43×24×15mm with a robust casing. Wide voltage range (4.8–10V) suits most LiPo/LiFe batteries.

Excellent Anti-interference: with DSSS&FHSS pseudo random algorithm to give R9DS with excellent anti-interference ability.

9/10 Channels: Support PWM/SBUS signal output, works with Radiolink AT9/AT9S/AT9S Pro/AT10/AT10II. Please make sure SYSTEM channel selection is 10ch mode when it works with AT10II 12 channels transmitter, or it won't workwell.

Fast Response: High resolution ratio of 4096, the stability of 0.5us, to provide a quicker, low-latency connection for the driver.

Long Range Control: outstanding control range up to 2.1 miles on air. (Depends on the actual using environment)

Quick to Bind and Anti-polarity Protection: no need any setting on transmitter when R9DS bind with radio. With reverse polarity protection circuit, not damage the receiver even you plug wrong polarity.

Radiolink R9DS receiver only supports Radiolink protocol.
Please note:
1.RD9S only work with Radiolink transmitter products: AT9S, AT9,AT10,AT10II.
2.Short push the ID set switch two times within 1 second it can change signal, while the LED change to red, it indicates PWM signal output, the blue/purple LED indicates SBUS signal output.
3.SBUS and PWM signal output, you can use 10 channels.

How to Match Code With Transmitter:
1. Place the transmitter and the receiver close to each other within 1 meter.
2. Turn on the transmitter, then power on the R9DS.
3. Connect CH3 of R9DS to ESC.
4. There is a black button on the R9DS, use a thin stick or pen press the binding button in one second until the receiver light starts blinking and release, after about 8 times blinking,match code success when receiver signal LED always on.
SBUS and PWM signal change:

Short press the ID SET switch two times within 1 second, the signal is changed from normal
PWM to SBUS. The red LED indicates the normal PWM and blue/purple LED indicates SBUS signal.

Two signal working mode:
(1)PWM signal output working mode:red LE