HappyModel EP1 RX 2.4G ExpressLRS ELBRUS Nano Long Range …, Woodlands

✓Sealed product in factory packaging
✓If the buyer asks to be tested, we will open the seal/packaging to re-test.

Hello Pilots, throughout the archipelago, this time HobbyQ Online wants to update the ExpressLrs Receiver from Happymodel, the ELRS V3.0.1 includes 2 antennas.

EP1_RX
Type: ISM
ESP8285 MCU
SX1280IMLTRT RF Module
Omnidirectional antenna
Frequency Range: 2400 MHz to 2500 MHz
Maximum receive refresh rate: 500Hz
Minimum receiver refresh rate: 25Hz
Working voltage: 5v
Weight: 0.42gram(without antenna)
Dimensions: 10mm*10mm*6mm
Peak gain: 2.23dB

Fastening procedures:

-Give power to PP/EP1/EP2 rx, wait until the LED on the RX turns off, immediately turn off the power, then repeat the steps above again. When the RX is turned on a third time, the LED light will start flashing twice, which means the RX enters fastening mode.
-Insert the other ES24TX or 2.4G ELRS TX DIY module into the Radio transmitter, and select External RF mode to the CRSF protocol, then you can find the ELRS menu from the Radio system (Need to copy the ELRS.LUA file to the SD-Card device first First), Go to ELRS and press [Bind], the LED on the RX module will become solid if it is successfully binding.
-The meaning of receiving LED status:
PP RX: The LED lights up continuously means the fastening is successful or the connection is intertwined; LED flashes twice means in binding mode; The slow flashing LED means there is no signal connection from the TX module
EP1/EP2 RX: The LED lights up continuously means the fastening is successful or the connection is braided; The LED flashes twice means in binding mode; The slow flashing LED means there is no signal connection from the TX module; The fast flashing LED means in hotspot mode WIFI, you can connect WIFI RX and upgrade RX firmware by visiting 10.0.0.1 from web bandages (password: expresslrs)

Package:
1 x RX Happymodel EP1
2 x Antennas
Heatsink
Item price includes shipping fee that should be borne by the buyer.